The mini bench vice comes with a reversible jaw, six holding pins and a center holding rod. This vise is specifically designed to be used on the jewelers bench.
The base is made from 3 mm steel that is slightly wider than the actual vise, so that the entire vise can be clamped into a large machine vise, should the need arise.
This multi-purpose vise fits on the Drill-Str8 Mini Drill Press to clamp wide tapered rings, flat round disks, tubing and wire on either a 90° or tilted table.
Both flat jaws are lined with Delrin so that any delicate jewelry piece held in the vise is not damaged. Both jaws are replaceable should they get worn.
The reversible jaws as well as the top holding pins are central to the function of this multi-purpose bench vise so that various sizes and shapes of jewelry components can be clamped securely whilst working on the piece.
Holding a ring in the Delrin lined flat jawsof the vise.
When the holding pins are inserted, rings and flat shapes can be drilled from the side.
With the outer jaw reversed, it becomes easy to hold and drill round pieces a 90° to the table.
There are three sizes of V grooves for different sized materials.
Using the large side V slot allows one to drill perpendicular holes in rods and tubing accurately.
The smaller V groove can be used to drill holes into material that is as small as 2 mm in diameter.
This mini vise is specifically designed to be used on the jewelers bench to clamp wide tapered rings, flat round disks, tubing and wire.
The mini bench vise comes with a reversible jaw lined with Delrin on the flat sides, six holding pins and a center holding rod.